0
Ultra luxurious 3D solution, special construction plan for scaffolding engineering
The longitudinal spacing of the vertical pole of the double row floor scaffold is 1500mm, the spacing of the horizontal pole is 900mm, the step...
0
Can’t distinguish the vertical and horizontal sweeping rods of the scaffold? Explain step distance, span, and waist bar in one go
The vertical sweeping rod is set along the length direction of the frame, and the horizontal sweeping rod is perpendicular to it. 15mm dywidag tie...
0
Ten key points must be checked for the acceptance of scaffolding in a construction site, and none of them can pass without them
What is the acceptance test for full house scaffolding? The first steel pipe fastener entering the site must have a certificate of conformity and a...
0
Requirements for the specification setting of main nodes and connecting wall components of external scaffolding
1. scaffolding screw jacks The intersection point of the upright pole, longitudinal horizontal pole, and transverse horizontal pole is the main node, and a transverse...
0
What is the height of a scaffold set up at once? JGJ130-2011 explicit regulations
According to JGJ130-2011 and the general specifications for construction scaffolding. 5×5 scaffolding The height of a scaffold should not exceed 2 steps from the top...
0
Why are construction sites now using flower basket pull rod suspension frames? This information has been explained to you directly!
More wonderful information has been updated on the official account in the past. scaffolding boards If you miss something and don’t get it, hurry up...
0
Construction method: High altitude steel pipe clip type mobile scaffolding construction method
Scan the code to add WeChat for free to receive more construction materials. slab prop nut If it is helpful to you, please forward this...
0
Two low-level errors were found in the scaffolding, and the supervisor found them and directly issued a rectification order! Appendix
This scaffold made two basic mistakes, the first being the position of the horizontal sweeping rod was reversed. shuttering prop nut .
0
Two key points must be identified during the acceptance of cantilever scaffolding, and any mistakes must be rectified
There are two safety hazards with this cantilever scaffold. The first one is that the number of U-shaped steel pull rings at the end of...
0
Complete set of acceptance standards for scaffolding scissor braces! 4 hard regulations are dismantled one by one
How to inspect the diagonal braces of scaffolding? Firstly, the number of diagonal braces crossing the uprights should comply with the specifications in the table....